| |
|
|
Indian Journal of Advances in Chemical Science Volume: 8,
Issue :1 , January 2020 |
|
|
|
| |
|
ISSN No.: 2320-0898 (Print);
2320-0928 (Electronic)
DOI: 10.22607/IJACS.2020.801006 |
| |
|
Research Article
|
| |
|
|
Optimization of Turning
Parameter for Roundness Investigation using
V-block Method
|
|
|
|
S. Raghu*, T. G. Mamatha,
M. Vishnoi, G. Moona, R. Sharma
|
|
ABSTRACT |
|
|
|
Roundness or circularity is a very
important surface characteristic that can effect on the performance
and behavior of machined parts. This paper introduces experimental
investigations on the effect of turning parameters on roundness
error of turned specimens using 90° V-block method and analysis of
variance techniques. For the study, the turning parameters such as
cutting speed and depth of cut were chosen. Aluminum 6061 specimens
are used for experimental investigations. The results of the
investigation indicate that depth of cut and cutting speed are
interrelated and have significant effects on roundness error. This
optimized design was minimized the roundness error. |
|
|
|
|
| |
|
|
Key words: Roundness,
V-block, Cutting speed, Turning and circularity |
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
